Month: September 2018
The kitchen is the most frequented room in your home and minor changes in the kitchen can create a whole new look for the home. My parents just did cabinet refacing to their whole kitchen and it felt like an entirely different house after it was completed. They did the whole nine yards, wood floors, new appliances, granite countertops, cabinet refacing. You may not have the means to do this drastic of a change to your kitchen, so you may want to consider just doing some cabinet refacing.
Cabinet refacing can really change the look of your cabinet as the cabinets do take up a lot of the surface area of your kitchen. It really adds to the beauty of the kitchen and your home in general. You need to consider a few things to decide if replacement is necessary or just a cabinet refacing job will do the trick.
If you have the stock cabinets that your home came with you may need to just need to do a little cabinet refacing of your cabinet. Check and make sure that your cabinet is still in good condition. You could just have a new paint job on it to get the new, improved look you want. A change of the handles can make the new look that you’re looking for as well as a part of cabinet refacing.
If you like the arrangement of the shelves and cabinets in your kitchen then this may be the method you want to use as a part of cabinet refacing. Decide what type of cabinet refacing front you want to replace it with, you basically have three choices: wood, stainless steel, or laminate. Wood cabinets are a little bit more pricey and are prone to warp through temperature changes but can give a very warm look to your kitchen. Many people are moving towards stainless steel for the durability and the modern look in their homes when refacing. The laminate may be the cheapest and still be able to get the wood look that you’re look for while getting a material that will last a long time in cabinet refacing.
Cabinet refacing is a great way to start your home improvement plans. The cabinets can change the entire feel of your kitchen which will also improve the look of your entire home. Cabinet refacing is cheap and effective!
Visit Cabinet Refacing
It’s really not as difficult as some people think to install their own aluminum fence… be it for around their backyard or for around their swimming pool.
The hardest part is the actual digging of the holes. They’re usually 2′ into the ground with a diameter of about 6″. You can use a standard post hole digger or make the process easier by using a hydraulic auger.
Before you start digging all the post holes (usually 72.5″ on center for a residential fence), make sure you mark off where your gates are going to be located. Keep in mind before digging your gate holes, that a 4′ wide gate is usually measured as the opening size from the inside edge of one gate post over to the near side of the other gate post.
More information about hanging a gate can be found at the link at the bottom of this page.
All the aluminum fence sections come pre-assembled and are ready to install. Once the post is in the ground, slide the fence rails into the holes in the posts and secure them with a self-tapping screw that goes into the post and through the rail inside of the post. Do this for each rail. Once that’s done, you can pour concrete into the post hole that you previously dug out. Time to move to the next hole and repeat the process.
To make sure that all the posts are in a straight line, tie a string to a stake and hammer it in the ground 1′ past or behind the one end or corner post with the other end connected to a stake in the ground 1′ past the last end or corner post in that line. Make sure that each post is right next to the string, but not touching it. Also make sure that each post is plumb by checking each side with a level… before the concrete has a chance to dry.
Continue this for each straight run of fence before attempting to hang the gate.
Further aluminum fence and gate installation instructions can be found in the link at the bottom of this page.
We hope you found this information helpful.
For more information about purchasing your own aluminum or vinyl fence, visit our website below.
We have some very unique styles of aluminum fence that are made from American aluminum extrusions and then fabricated in North Carolina, USA… to make them completely American made and assembled. Not very many of our competitors can say they same.